SANMOTION F3 - 3 phase (STEPPING SYSTEMS)

SANMOTION F3　( 3-phase )
Low introduction cost, with vibration characteristics similar to standard 5-phase motor driving. Combines high accuracy with high precision and cost performance.

Vibration and noise performance comparable to standard 5-phase motor driving.
The current ratio of the winding can be adjusted by combining with a micro-step 3-phase driver. Since the step angle can be finely divided, it generates vibrations similar to those of
5-phase stepping motors, and superior to 2-phase stepping motors. Low vibration, low noise, and low cost compared to 5-phase stepping motors. And, with only 3 lead wires, wiring
work is reduced.

Standard specification meets international safety standards
Standard SANMOTION F series stepping driver models comply with international product safety standards (UL standard).

Options
A wide range of options are available, such as breakers that block circuits and protect power lines from overcurrent, and noise filters that prevent power line noise. Moreover,
they have high versatility, and can be connected to other products using various optional cables and connectors.

Rich lineup supports product development
The SANMOTION F3 standard lineup consists of 8 models, with single- and dual-shaft types, each of which is available in 42, 50, 56, and 60 mm sq. sizes. Selection can be made
to suit the application. As the leading Japanese manufacturer of 3 phase stepping motors, we support our customer's equipment design from selection to production.

Stepping Motor Specifications:

• Basic Step Angle: Operates at a basic step angle of 1/16 (0.075° per pulse) with DIP switch 'C' set to 'ON'.

• System Configuration: Includes I/O signal functions and step angle settings controlled by DIP switches A, B, and C.

• Input and Output Signal Specifications: Maximum pulse duty is 50%. External limit resistance R is required to limit input current to approximately 15 mA when input
  signal crest value exceeds 5 V.

• Motor Models and Characteristics: Specifications for models like 103H5332-0340 include holding torque, rated current, and pulse rate-torque characteristics.

• General Specifications: Operates within -10 to +50°C and 20 to 90% humidity without condensation. Insulation class B, with resistance not less than 100MΩ.

• Mechanical Specifications: Details on axial and radial play, shaft runout, and allowable loads for different flange sizes.
   

3-Phase Stepping Motor Drive IC (PMM3501):

• Features: Includes a micro step sine wave drive driver, built-in current detection resistor, and uses MOSFET to reduce heat generation.

• Maximum Ratings: Handles source voltage up to 30 V and phase current of 6 A.

• Recommended Operating Conditions: Source voltage-1 is 24±10% V, and source voltage-2 is 5.0±5% V.